Ikelite manual strobe controller

manual mode utilizing any power settings provided on the Substrobe. Using the Conversion Circuitry (Set DS Substrobe to TTL mode)-Mode and Compensation Buttons The Conversion Circuitry default is set to TTL. To switch between TTL and Manual Modes, depress both Mode Buttons at . Manual control increments: (10) 1/2 f-stop. Video/modeling light: lm LED. Color temperature: K. Guide number at 1m / ISO Flashes per charge: full power. Recycle time: seconds at full power. Electrical sync connection: Ikelite ICS 5-pin bulkhead. Battery: V mAh NiMH. Dimensions: " diameter x 7" length (96 x. Attaching an Ikelite Strobe Arm to the Housing Handle..P. Table of Contents- continued Usage The Conversion Circuitry also offers Manual exposure control with 3 f-stops of underexposure control in 1/2 stop increments. The Conversion Circuitry is powered by the Ikelite DS Substrobe when.

The Conversion Circuitry also offers Manual exposure control with 3 f-stops of underexposure control in 1/2 stop increments. The Conversion Circuitry is powered by the Ikelite DS Strobe when connected to the housing with the single or dual sync cord. When using two strobes with the dual sync cord, the primary. If you want to use Ikelite housings, you would need a new Ikelite cord, non-TTL type, and you would be limited to manual strobe control as I said. I think the cost of a new strobe would be small compared to the cost of a decent housing for a newer DSLR, so this might be false economy. If your strobe doesn't have a power setting, you will be forced to change your distance. That's why it's important to have multiple power settings on a strobe. That's one of the reasons I like Ikelite strobes; the SS has 4 power settings: full, 1/2, 1/4, and 1/8. You can almost always find a power setting that will work with the picture.

Ikelite Manual Strobe Controller for DS Digital Series Substrobes # Provides 10 manual power settings in half-stop increments fo r SubStrobe DS and DS models. The Manual Controller has a slave sensor allowing it to be triggered by another strobe; or any of our sync cords can be attached to the Controller bulkhead. The Conversion Circuitry also offers Manual exposure control with 3 f-stops of underexposure control in 1/2 stop increments. The Conversion Circuitry is powered by the Ikelite DS Strobe when connected to the housing with the single or dual sync cord. When using two strobes with the dual sync cord, the primary. The Manual Controller has a slave sensor allowing it to be triggered by another strobe; or any of our sync cords can be attached to the Controller bulkhead. The Controller attaches to the strobe and mounts near the housing, providing maximum versatility and control of flash exposure. It can be used with normal or pre-flash camera and strobe systems.